Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revisionNext revisionBoth sides next revision | ||
| apps:all:jcgui [2009/12/23 17:49] – created lee | apps:all:jcgui [2014/02/27 11:26] – j_e_f_f_g | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| {{metacard> | {{metacard> | ||
| a little Host warped around the convolution engine libzita and [[apps: | a little Host warped around the convolution engine libzita and [[apps: | ||
| - | {{tag>Comvolution}} | + | It's designed to search/load and run IR-*.wav files on a local machine |
| + | with jconvolver. It include a settings widget, were gain, delay, min/max | ||
| + | mem and mode can set and the used wave file and a part of it | ||
| + | (offset/ | ||
| + | As default, the min mem is set to your jack frame rate, the max mem is | ||
| + | set to the file length. | ||
| + | Those settings will saved in a config file, and used to start | ||
| + | jconvolver. Jc_Gui itself provide a Stereo Host, with master gain, tone | ||
| + | (bass, | ||
| + | jconvolver per channel delay and gain controllers, | ||
| + | to mix the output from jconvolver with the original source. | ||
| + | |||
| + | So, you need only to connect Jc_Gui with your in/out put ports, (Jc_Gui | ||
| + | provide a port map there for), and can then load your IR files and start | ||
| + | stop jconvolver easy over the Gui. | ||
| + | |||
| + | {{tag>Convolution JACK dead_link}} | ||
| ~~META: | ~~META: | ||
| ~~META: | ~~META: | ||
| - | ~~META: | + | ~~META: |
| ~~META: | ~~META: | ||
| - | ~~META: | + | ~~META: |
| ~~META: | ~~META: | ||
| - | ~~META: | + | ~~META: |
| - | ~~META: | + | ~~META: |
| - | ~~META: | + | ~~META: |
| - | ~~META: | + | ~~META: |