Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hw:rme_fireface_ucx [2020/07/14 09:43] – [Software] magdesign | hw:rme_fireface_ucx [2020/07/19 16:41] – [Software] magdesign | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== General ===== | ===== General ===== | ||
- | The [[http:// | + | The [[http:// |
+ | |||
+ | Its not officially | ||
===== Software ===== | ===== Software ===== | ||
- | In CC (Class Compliant) mode the RME Fireface UCX works out of the box without having to use a patched kernel or flashing some firmware (tested | + | In CC (Class Compliant) mode the RME Fireface UCX works out of the box without having to use a patched kernel or flashing some firmware (tested |
- | ALSA will see only one channel, but after installing QJackCtl from Ubuntu-Studio installer everything works. | + | ALSA will see only one channel, but after installing QJackCtl from [[https:// |
Listed audio channels in Jack correspond to: | Listed audio channels in Jack correspond to: | ||
CH 1-8 => Analog 6.3mm Jack Out | CH 1-8 => Analog 6.3mm Jack Out | ||
+ | |||
+ | |||
CH 9 - 10 => Spdif | CH 9 - 10 => Spdif | ||
- | CH 11 -18 => Adat/Tosink | + | |
+ | |||
+ | CH 11 -18 => Adat (Tosink) | ||
You might run some pre-start and post-start scripts from QJackCtl to get rid of some pulseaudio standard routings to the first 2 channels. | You might run some pre-start and post-start scripts from QJackCtl to get rid of some pulseaudio standard routings to the first 2 channels. | ||
- | See here: https:// | + | [[ https:// |
+ | Get working scripts [[ https:// | ||
We figured out that custom routings are only loaded when QJackCtl is started from GUI rater than activated from command line only. | We figured out that custom routings are only loaded when QJackCtl is started from GUI rater than activated from command line only. |