Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
wiki:rockchip [2013/06/26 11:00] – [Available flavors] autostatic | wiki:rockchip [2013/06/26 11:15] – [Available flavors] autostatic | ||
---|---|---|---|
Line 11: | Line 11: | ||
* The [[http:// | * The [[http:// | ||
- | |{{: | + | | {{ : |
- | |{{: | + | |
+ | | {{ : | ||
===== Linux ===== | ===== Linux ===== | ||
Line 18: | Line 20: | ||
[[http:// | [[http:// | ||
+ | |||
+ | ===== Using JACK ===== | ||
+ | |||
+ | JACK (JACK Audio Connection Kit), often referred to as jackd, is a | ||
+ | >//" | ||
+ | \\ | ||
+ | JACK was designed from the ground up for professional audio work, and its design focuses on two key areas: synchronous execution of all clients, and low latency operation."// | ||
+ | |||
+ | ==== Patching JACK ==== | ||
+ | |||
+ | You will need a recent git checkout of Jack2 or a patched Jack1 for Rockchip based devices otherwise you will encounter the infamous "Bus error" when starting JACK. This is because JACK uses packed structs and the Rockchip RK3066/ | ||
+ | |||
+ | Patches can be found here: https:// | ||
+ | The patches are relatively simple so they can be easily adapted for other JACK versions. | ||
+ | |||
+ | When using Jack2 you might want to disable dbus dependent code in JACK components if you want to run Jack2 on a headless RPi (so without X). You can do this by building Jack2 from source without the '' |