Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
wiki:wineasio_and_reaper [2014/03/11 10:29] – [Installing REAPER on a 64bits system] daeavelwyn | wiki:wineasio_and_reaper [2014/04/17 19:45] – [Configure REAPER for WineASIO and JACK] daeavelwyn | ||
---|---|---|---|
Line 41: | Line 41: | ||
if you're in KXStudio 64bit, make sure to install the 32bit packages: | if you're in KXStudio 64bit, make sure to install the 32bit packages: | ||
- | '' | + | |
- | sudo apt-get install reaper:i386'' | + | sudo apt-get install reaper:i386 |
- | then try again the registering: | + | then don't forget to register wine as mentionned in the previsous chapter |
- | + | ||
- | '' | + | |
if that fails try with a clean wineprefix: | if that fails try with a clean wineprefix: | ||
- | '' | + | |
- | wine64 regsvr32 wineasio.dll'' | + | wine64 regsvr32 wineasio.dll |
If this 2nd one works but the previous fails, then you have a broken default wine prefix... | If this 2nd one works but the previous fails, then you have a broken default wine prefix... | ||
Line 60: | Line 58: | ||
- Choose Device under the Audio section from the list to the left of the Preferences window | - Choose Device under the Audio section from the list to the left of the Preferences window | ||
- Choose ASIO from the Audio drop-down menu at the top of the Audio device settings options. You should then see ' | - Choose ASIO from the Audio drop-down menu at the top of the Audio device settings options. You should then see ' | ||
- | - Choose Audio from the list to the left of the Preferences window and untick 'Close audio device when stopped and application is inactive' | ||
- Apply, OK, done! | - Apply, OK, done! | ||
+ | =====REAPER / Claudia (or catia) issue===== | ||
+ | |||
+ | To prevent some misconfiguration between REAPER and Cadence tools (Claudia or Catia), you have to set REAPER options. | ||
+ | So, in REAPER, go to options > Preferences, |