Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| apps:all:jcgui [2009/12/24 12:46] – 88.70.251.170 | apps:all:jcgui [2021/08/08 18:35] (current) – removed gootz | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== jcgui ====== | ||
| - | {{metacard> | ||
| - | a little Host warped around the convolution engine libzita and [[apps: | ||
| - | It's designed to search/load and run IR-*.wav files on a local machine | ||
| - | with jconvolver. It include a settings widget, were gain, delay, min/max | ||
| - | mem and mode can set and the used wave file and a part of it | ||
| - | (offset/ | ||
| - | As default, the min mem is set to your jack frame rate, the max mem is | ||
| - | set to the file length. | ||
| - | Those settings will saved in a config file, and used to start | ||
| - | jconvolver. Jc_Gui itself provide a Stereo Host, with master gain, tone | ||
| - | (bass, | ||
| - | jconvolver per channel delay and gain controllers, | ||
| - | to mix the output from jconvolver with the original source. | ||
| - | |||
| - | So, you need only to connect Jc_Gui with your in/out put ports, (Jc_Gui | ||
| - | provide a port map there for), and can then load your IR files and start | ||
| - | stop jconvolver easy over the Gui. | ||
| - | |||
| - | {{tag> | ||
| - | |||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||
| - | ~~META: | ||