This is an old revision of the document!



a little Host warped around the convolution engine libzita and jconv/jconvolver. It's designed to search/load and run IR-*.wav files on a local machine with jconvolver. It include a settings widget, were gain, delay, min/max mem and mode can set and the used wave file and a part of it (offset/length) could choosed. As default, the min mem is set to your jack frame rate, the max mem is set to the file length. Those settings will saved in a config file, and used to start jconvolver. Jc_Gui itself provide a Stereo Host, with master gain, tone (bass,middle,high)controllers, balance slider, and for the output to jconvolver per channel delay and gain controllers, and a wet/dry slider to mix the output from jconvolver with the original source.

So, you need only to connect Jc_Gui with your in/out put ports, (Jc_Gui provide a port map there for), and can then load your IR files and start stop jconvolver easy over the Gui.

apps/all/jcgui.1261658765.txt.gz ยท Last modified: 2009/12/24 13:46 by